Changelog

I often find myself making minor changes on products after releasing them so I will use this blog as an informal way to track all the changes I've made :) 

-----
10/6/2026: Panel Organizer Update

The issue: Panels falling down in between the gaps of the panel organizers. 

The reason: The panel organizers were designed as a frame and can not stand up on it's own. It requires being boxed in by panels and using the surrounding walls for support. However, I failed to account for the stretching of plastic that might occur on the side walls, which causes the width of the cube to be wider than the actual panel. 

The solution: Adding a lip that sticks out of each groove to account for the extra width in the space. This catches the panels that might have otherwise fallen down. 

Additional changes: Removed the little legs sticking out at the bottom because they weren't providing a function and made the panel organizers not as flat as I'd like. Also increased the thickness inside the groove so it doesn't bend and break as easily.

10/6/2026: Skadis Model Update

Fixed an issue where the skadis panel was too loose and would fall out of my 3d printed connectors.

10/6/2026: Awning Leg update

Fixed an issue with the awning legs where it would fall out when rotated to the upright position. Files are updated on the google drive and can be found as Leg_V03 in the stl file. If you ordered a physical awning from me with this issue, please contact me and I can ship you a replacement! 

9/11/2026: Panel Cover Update

I was having a lot of issues with the panel covers ripping when I was only printing one 0.2mm thick layer so I adjusted it to print two 0.1mm thick layer but that caused some rips to occur and some colors to be really stuck to the build plate (especially the lavender). After fighting this for weeks, I realized 0.1mm might be too thin for the first layer and was causing the nozzle to print too close to the build plate. I realized this when I checked Bambu's 0.08mm setting and saw that the first layer was still set to 0.2mm.

So to have the first layer be 0.2mm AND have two layers as the base, I have updated the panel cover so the base is 0.3mm thick. The result is that it peels off the build plate way easier and has almost no defects! :)